Abstract:
Представлены результаты исследования структуры и фазового состава минералокерамики ЦМ-332 в исходном состоянии и после обработки тлеющим разрядом при различных его энергетических характеристиках. Установлено, что обработка тлеющим разрядом приводит к измельчению фрагментов Al2O3,
инициированию радиационно-ускоренной диффузии, которая способствует размытию межфазных границ с формированием двойного оксида NiAl2O4 и равномерному распределению элементов в поверхностном слое глубиной до 140 мкм, изменению параметров кристаллической решетки, а также напряженного состояния. Указанные изменения позволяют повысить твердость обработанных многогранных пластин на 360…370 HV и износостойкость в 1,30…1,35 раза по отношению к необработанным.
This paper presents the results of the research into the structure and phase composition of cutting ceramics CM-332 in its initial state and after it was treated by glow discharge with different energy characteristics. It has been found that the glow discharge treatment leads to the grinding of Al2O3 fragments; the initiation of radiation-accelerated diffusion, which contributes to the blurring of interphase boundaries with the formation of double
oxide NiAl2O4 ; the uniform distribution of elements in the surface layer up to 140 microns deep, as well as to the changes in the crystal lattice parameters and the changes in the stress state. These changes make it possible to have a 360...370 HV increase in the hardness of multi-faceted treated plates and a 1.30…1.35-fold increase in their wear resistance, compared to the plates that were not subjected to the glow charge treatment.